Proline

Find all tools you need to build your wheels professionally!

DT truing stand

The DT Swiss truing stand is the ultimate stand used by professionals. It is made of precision machined, polished and anodized aluminium with hardened steel guides and mounts.

  • High-end quality and easy handling
  • Quicker wheel building
  • Compatible with all current bicycle wheels (12" – 29") with quick release or thru axle
  • Three precision multilink arms providing a wide range of contact points
  • Playfree precision gauges to measure lateral and vertical dish
  • extremely stiff and solid clamping
  • Wheel can be trued with tires
  • Can be installed on a table or clamped into a vice
  • Upgrades: Analog gauges including measuring insert with ball, special measuring inserts with rounded washers or ball bearing steel roll, truing adapters for all axle configurations

DT tensio

The tensiometer is a high-precision tool to measure spoke tensions. Developed by DT Swiss and 100 % Swiss made, it is used to precisely measure the spoke tension step by step during the wheel building process.

The digital tensiometer is equipped with a digital gauge, allowing fast and easy reading of measurements. Using its Opto-RS232 data output device, the measured values can be transmitted directly to a PC or printer via connecting cable.

The DT Swiss tensiometer is a necessity for any professional wheel builder. Can be used with all spoke types including flat spokes. Includes case.

Shock pump

  • Fits all DT Swiss suspension forks and shocks, 20bar/300PSI max. pressure
  • Minimal packing size thanks to removable gauge and foldable hose
  • Anti air-loss coupler for precise set-ups (no air loss when removing pump from valve)
  • Suitable for right- and left-handed people
  • Air bleeder for fine tuning
  • Rubber padded gauge housing

DT Nipple wrenches

The matching nipple wrench for DT Swiss nipples with an internal drive. Available for DT Swiss nipples with hexagonal (blue handle), torx (black handle) or square (red handle) heads.

– Less hand force needed
– Facilitates work with bladed spokes
– Developed by DT Swiss
– Also suitable for high profile rims (max. 100 mm)

Classic Nipple Wrenches

Professional tool for a precise fit onto the torx nipple (black) and square nipple (red).

DT aerolite / new aero spoke holder

These spoke holders effectively eliminate spoke twist when truing or building wheels with bladed spokes (e.g. DT aerolite). Thanks to their design, the spoke can be held close to the nipple, which eliminates twisting. Compatible with all DT Swiss nipple wrenches.

Multitool

Nipple wrench for DT Swiss torx and square nipples as well as for holding bladed spokes.

Nipple driver

Makes screwing the nipple onto the spoke quicker and easier.

Nipple guide

Facilitates the insertion of nipples into deep section rims.

Spoke head punch

Punch with concave head, fitting DT Swiss spoke heads. Improves seating of the spoke head in the hub flange.

Spoke ruler

For measuring spoke lengths and diameters.

Spoke length chart

Allows for precise spoke length calculation. Works when using rims with an ERD from 390 to 630 mm, low- and high-flanged hubs (24 to 48 holes), radial to 4-cross lacing patterns. Precision ± 0.5 mm, Size 70 x 52 cm. Also check out our free program «spokes calc» on www.dtswiss.com – an easy and fast way to calculate your spoke lengths.

Service tool case

Several service and maintenance tool kits are available for DT Swiss products.